65
v1.01
M215SC User Manual Appendix 1 - Base Station Settings
System Logs
• On the Syslog Settings page, you can enter settings related to system logging activities. It supports the
following logging modes:
◦ Syslog server
◦ Volatile file
Settings Description
Enable Syslog Enable log output to syslog server.
Server address Syslog server IP address.
Server port Syslog server port.
Log Level Sets the log level. The higher the level, the larger the debug output.
5—ALL
4—DEBUG
3—INFO
2—WARNING
1—ERROR
0—CRITICAL
The logging levels are:
CRITICAL: Operating conditions to be reported or corrected immediately (for example, an internal
component failure or file system error).
ERROR: Non-urgent failures - unexpected conditions that won't cause the device to malfunction.
WARNING: An indication that an error or critical condition can occur if action is not taken.
INFO: Normal operational messages.
DEBUG: Developer messages for troubleshooting/debugging purposes.
• Under Network Trace, you can capture network trac related to the phone's activity and save the capture
as a .pcap file. The file can be used for diagnostic and troubleshooting purposes.
Performing a network trace:
1. Start a network trace by clicking Start. The button changes to Stop.
2. Stop the network trace by clicking Stop.
3. Save the trace by clicking Save to file. Your browser should prompt you to save the capture.pcap file.
• Under Download Log, you can save the system log to a file.
1. Click Save Log to file.
2. After your browser prompts you to save the system.log file, save the file in the desired location.
To Previous Page
Loading...
