Snom M215 SC Bundle - Page 56

56
v1.01
M215SC User Manual Appendix 1 - Base Station Settings
Maximum Number of Calls Select the maximum number of concurrent active calls allowed for that account.
Feature Synchronization Enables the phone to synchronize with Broadworks Application Server. Changes to
features such as DND, Call Forward All, Call Forward No Answer, and Call Forward
Busy on the server side will also update the settings on the handset menu and WebUI.
Similarly, changes made using the handset or WebUI will update the settings on the
server.
DTMF method Select the default DTMF transmission method. You may need to adjust this if call
quality problems are triggering unwanted DTMF tones or you have problems sending
DTMF tones in general.
Unregister after reboot Enables the phone to unregister the account(s) after rebooting-before the account(s)
register again as the phone starts up. If other phones that share the same account(s)
unregister unexpectedly in tandem with the rebooting phone, disable this setting.
SIP Server Settings Description
Server address Enter the IP address or domain name for the SIP server.
Server port Enter the port number that the SIP server will use.
Registration Settings Description
Server address Enter the IP address or domain name for the registrar server.
Server port Enter the port number that the registrar server will use.
Expiration Enter the desired registration expiry time in seconds.
Registration Freq (secs) Enter the desired registration retry frequency in seconds. If registration using the
Primary Outbound Proxy fails, the Registration Freq setting determines the number of
seconds before a registration attempt is made using the Backup Outbound Proxy.
Outbound Proxy Settings Description
Server address Enter the IP address or domain name for the proxy server.
Server port Enter the port number that the proxy server will use.
Backup Outbound Proxy Settings
Server address Enter the IP address or domain name for the backup proxy server.
Server port Enter the port number that the backup proxy server will use.
Audio Settings Description
Codec priority 1 Select the codec to be used first during a call.
Codec priority 2 Select the codec to be used second during a call if the previous codec fails.
Codec priority 3 Select the codec to be used third during a call if the previous codec fails.
Codec priority 4 Select the codec to be used fourth during a call if the previous codec fails.
Codec priority 5 Select the codec to be used fifth during a call if the previous codec fails.
Enable voice encryption (SRTP) Select to enable secure RTP for voice packets.
Enable G.729 Annex B When G.729a/b is enabled, select to enable G.729 Annex B, with voice activity
detection (VAD) and bandwidth-conserving silence suppression.
Preferred Packetization Time (ms) Select the packetization interval time.
Quality of Service Settings Description
DSCP (voice) Enter the Dierentiated Services Code Point (DSCP) value from the Quality of Service
setting on your router or switch.
DSCP (signalling) Enter the Dierentiated Services Code Point (DSCP) value from the Quality of Service
setting on your router or switch.