Solartron 1260 - Page 105

9.4.2
Effect of
‘'Break”
Command
If break
is commanded
during
a binsort
the
instrument remembers
the point
at
which
it was
stopped
and
restarts
from
that point. The
"stop on” value*
which
is
displayed
on sort
completion
includes
the
number
of tests
made
before
break
was
commanded.
^Number
of components
tested, see
Section 9.3.4.
9.5
PROGRAM
KEYSWITCH
The setting
of the PROGRAM
keyswitch on the
rear
panel determines
the
use of
the
non-volatile
memory
for scaling
functions
(see Section
9.1.4). Two
switch
positions
are used:
a)
SUPERVISOR
A scaling
function may
be
stored in,
or recalled
from,
any
location,
from 1 through
18. All
locations
may
be cleared.
In
SUPERVISOR
mode the
instrument
takes
several
seconds to initialize.
b)
NORMAL
c) OPERATOR
A scaling
function may
be recalled
from
any location,
but
may
be stored only
in
locations 1
through
9.
Only
locations
1 through
9 may be cleared.
Reserved
for future
use.
To
set the instrument
into
the supervisor
or normal
mode,
turn
the key
to the
appropriate
position and command
"BREAK”.
To protect
the
contents
of
the
non-volatile
memory,
operate
the
instrument
in
the normal
mode
whenever
possible.
t
5.36
JWS/1
260/2