Solartron 1260 - Display; Power-Up Status

POWER-UP STATUS
POWER
Off
lM.j
on
On power-up
the
instrument is tested
automatically and the
resuiting
control status
is
indicated in a
power-up
message.
This message is
important and
should be
understood
before
using the
instrument. The
various messages
which may
be
displayed are:
POWER
RESTORED
The normal power-up
message.
This
shows that the
instrument has
correctly
remembered the
control and
measurement data
that were
in
its memory
when power
was interrupted.
The generator
output is switched
off.
RESET This message
may be
displayed
if
a
board has
been removed
from
the
instrument. All control
settings are set
to the
default state.
Stored parameters*
learn
programs, and
history file
data are available
for recall.
INITIALIZED This message
may be
displayed
if power has
been down for a
considerable
time. All
control
settings are reset to
the default
state, and stored
parameters,
learn programs,
and history
file data are
erased.
A
further message
may
appear with any of
the above
messages i.f the
instrument
needs recalibration:
"75.
CAL
DATA
CORRUPT” is
displayed if one
copy of
the calibration data has
been
corrupted. The
instrument is
usable, but
should be
recalibrated as
soon
as
possible.
"76.
RECALIBRATE” is
displayed if both
copies of
calibration data
have been
corrupted. The
instrument
should
be
recalibrated
before
further use.
DISPLAY
*
Control
information or
measurement
results are
displayed, in accordance
with the
operating state of
the
instrument. Examples
of the
display format are
shown in
Section
5
of this
chapter and in
Chapter 5 "Menu
Terms”.
If a bad
command is
given an
error message is
displayed
also. The meaning of each
error
message
is
explained in
Chapter 9.
3.6
JVVS/X
260/1