Solartron 1260 - Page 176

78.
ILL
FREQUENCY
79.
ILL CAL. SOURCE
Illegal
frequency. Calibration frequency incorrectly
set.
Illegal
calibration source.
2.9
GROUP
8: MEASUREMENT
VALIDITY
MESSAGE
81. INPUT
OVERLOAD
82. AUTOINT.
FAILED
83.
O/L +
A. INT FAIL
EXPLANATION
Overload
on displayed
channel(s).
Auto-Integration terminated
before valid
result
obtained.
Combination of Errors 81
and 82.
84. MONITOR FAILED
85. O/L + MON. FAIL
86. MON.+ A. INT
FAIL
87. OL, MON. + A/I
FAIL
88. AUTO IMPED
ERROR
Failure to reach
the target value
at the monitor
input, within
the defined
error%.
Combination
of Errors
81 and 84.
Combination
of Errors
82 and 84.
Combination of Errors
81,
82 and 84.
When display CIRCUIT
is set to
[auto]
the analyzer
MODE must
be set
to
[auto impedance].
89.
G. DEL NOT SET UP Group
delay
not
set.
2.10 GROUP
9
:
STORE/RECALL
MESSAGE
90. NO
SUCH SET-UP
91. SET-UP
STORED
EXPLANATION
Attempt
made to recall or clear
an empty set-up
store; or
a checksum error
has been detected
on
recalling
a stored set-up.
Control set-up stored.
92. SET-UP
RECALLED
Control set-up recalled.
93. SET-UP
CLEARED Control
set-up cleared.
94.
SET-UP
EXISTS Set-up store in
use. Before
the store can be re-used
it
must
be cleared.
95. RESULT
STORED Present result
stored.
98.
FUNCTION
EXISTS Attempt
made to write
a function under
a number
which is already
in
use. A used function
must be
cleared before a new
function can
be
written
under
the same
number.
99. NO
SUCH FUNCTION
Attempt made
to scale a measurement
result by
a
non-existent
function.
9.8
JWS/1260/2