Solartron 1260 - Page 97

8.1.1 HEADING
Headings can
be included
in the
data that
are
output
to RS423
and
the GPIB.
Headings are
intended
for
use with
printers
and VDUs,
when data
are presented
in
tabular form.
A heading
is
assigned
to each
column to
indicate the
data type, units,
etc.
* [off]
No
headings
are output.
•
[on]
Headings
are output
to:
a) the RS423
port, if MODE
is set for [printer].
b) the GPIB
port, if Talk
Only is selected.
Headings are
output when:
a) HEADING
[on] is entered,
regardless of
whether [on] was
selected
previously
or not,
b) a change
is made
to any control
parameter which
invalidates
existing
headings.
8.2
[GPIB
CONFIGURE]
GPIB
parameters.
(The
device address, Talk
Only, and
the input command
terminator
are
set on a rear
panel switch. PAR
POLL,
P
SENSE,
and SER POLL
are
set by remote
command only.)
8.2.4
TERM.
Output terminator.
The
character,
or characters, with which
each
measurement
result
is terminated:
»
[cr If]
Carriage
return
and line feed.
*
[crlf+EOI]
Carriage return,
line feed and
the signal
EOI (end or identify).
[cr]
Carriage
return.
• [cr +
EOI]
Carriage
return and
EOI.
8.2.5 SEP.
Output separator.
The character with
which
output data Fields
are
separated:
• [comma]
Comma
separator.
* [terminator]
Separator
same as
terminator.
JWS/1
260/1