4-7
BVW-55
4-2-5. Stationary Heads and Tape Cleaner Cleaning
w
Keep bare hands away from the sharp edge of the tape cleaner to avoid cuts and injuries.
Pay careful attention when cleaning the tape cleaner.
Caution
Be careful not to damage the head surface when cleaning the stationary heads.
Tools
. Cleaning cloth: 3-184-527-01
. Cleaning fluid: 9-919-573-01
Procedures
1. Clean the tape running surfaces of the full-erase head, tape cleaner, CTL head, AT erase head and AT
head in the vertical direction with a cleaning cloth moistened with a cleaning fluid.
m
. An error may occur in the playback or recording when magnetic powder attaches to the head gap
portion of the full-erase head, CTL head, AT erase head or AT head. Remove the magnetic powder
completely during cleaning.
. Do not contact the edge portion of the tape cleaner with bare hands.
. Pay careful not to damage the tape cleaner.
2. After cleaning, wipe them with a dry cleaning cloth two or three times.
4-2. Cleaning
Stationary Heads and Tape Cleaner Cleaning
AT erase head
AT head
CTL head
Full-erase head
Tape cleaner
To Next Page