3-1
BVW-55
3-1. Overview of Maintenance Mode
This unit has the maintenance mode that is useful during
maintenance and trouble diagnosis.
This maintenance mode consists of the four modes below.
The contents of the maintenance mode are superimposed
on the LCD monitor and the video monitor connected to
the VIDEO OUTPUT 2 (SUPER) connector.
To superimpose the contents of the maintenance mode, set
the SUPER item on the general setting page of the sub
LCD menu to ON. (For the sub LCD menu. refer to the
operation manual.)
M0 : TAPE MAINTENANCE ............. (Section 3-2)
This mode is used for maintenance of a VTR part.
In this manual, explains tape maintenance items for
operation check only.
For adjustment and others, refer to the maintenance manual
part 2 volume 1.
M2 : ERROR LOGGER..................... (Section 3-3)
This mode is used to display the record of errors (error
logging) that occur in this unit.
M3 : OTHERS ................................... (Section 3-4)
This mode is used for checking the others.
M4 : SETUP MAINTENANCE........... (Section 3-5)
This mode is used for the setup menu.
Section 3
Maintenance Mode
To Next Page
Loading...
