2-31
BVW-55 P2
BETACAM PB ADJUST MODE
A35:DM VR 4
GUARD BAND METAL-Y 22
GUARD BAND METAL-C 1A
GUARD BAND OXIDE-Y 26
GUARD BAND OXIDE-C 2F
OMC DC METAL-Y E4
OMC DC METAL-C D0
OMC DC OXIDE-Y D0
OMC DC OXIDE-C D0
*
BETACAM PB ADJUST MODE
A34:DM VR 3
SUB METAL-Y-A A4
SUB METAL-Y-B A4
SUB METAL-C-A 70
SUB METAL-C-B 70
SUB OXIDE-Y-A B6
SUB OXIDE-Y-B B6
SUB OXIDE-C-A AA
SUB OXIDE-C-B AA
*
BETACAM PB ADJUST MODE
A33:DM VR 2
MAIN METAL-Y-A BC
MAIN METAL-Y-B BC
MAIN METAL-C-A 91
MAIN METAL-C-B 91
MAIN OXIDE-Y-A A8
MAIN OXIDE-Y-B A8
MAIN OXIDE-C-A A0
MAIN OXIDE-C-B A0
*
BETACAM PB ADJUST MODE
A32:DM VR 1
EQ1 METAL-Y-A 7F
EQ1 METAL-Y-B 81
EQ1 METAL-C-A 77
EQ1 METAL-C-B 81
EQ1 OXIDE-Y-A AD
EQ1 OXIDE-Y-B AF
EQ1 OXIDE-C-A 94
EQ1 OXIDE-C-B 9D
*
A32 : DM VR 1
This menu is used to adjust the frequency characteristics of
a primary cosine equalizer (DM-121 board).
There are adjustment items for metal and oxide tapes.
Each adjustment item is provided proportionally to the
number of heads (Y-A, Y-B, C-A, and C-B).
Example of display
A33 : DM VR 2
This menu is used to adjust the frequency characteristics of
a secondary cosine equalizer (main) (DM-121 board).
There are adjustment items for metal and oxide tapes.
Each adjustment item is provided proportionally to the
number of heads (Y-A, Y-B, C-A, and C-B).
Example of display
A34 : DM VR 3
This menu is used to adjust the frequency characteristics of
a secondary cosine equalizer (sub) (DM-121 board).
There are adjustment items for metal and oxide tapes.
Each adjustment item is provided proportionally to the
number of heads (Y-A, Y-B, C-A, and C-B).
Example of display
A35 : DM VR 4
This menu is used to adjust the guard band width and to set
the DC offset level of an over-modulation compensation
circuit.
There are adjustment items for metal and oxide tapes.
Each adjustment item is provided proportionally to the
number of video channels (Y and C).
Example of display
2-2. TAPE Maintenance Mode (M0)
2-2-5. BETACAM PB ADJUST Mode (A3)
To Next Page