4-9
BVW-55 P2
PWH1.4 x 3.5
PWH1.4 x 3.5
PWH1.4 x 3.5
A
ME gear
Install the ME gear with the
chamfered side up.
Notch
Plate (2)
Stop washer
ME gear
Bearing of GB(3)
gear assembly
9. Plate(2) installation
(1) Install the plate(2) into the gear box housing,
and confirm that the bearing at the tip of the
GB(3) gear assembly is firmly put into the
hole of plate(2).
(2) While moving the plate(2) in the direction of
the arrow A, fasten the plate(2) with the three
screws.
10. ME gear installation
Install the ME gear with a new stop washer.
n
Align the notch at the tip of the shaft with the
hole of the ME gear when the ME gear is in-
stalled.
4-2. Gear in Gear Box Replacement
11. Timing belt installation check
Check that the timing belt is put on the pulley of
the threading motor. If the timing belt is not put,
remove the threading motor assembly from the
mechanical deck once, then put the timing belt on
the pulley.
12. AT head assembly installation
Install the AT head assembly.
(Refer to Section 3-15.)
13. VH cleaner assembly installation
Install the VH cleaner assembly.
(Refer to Section 3-6.)
Adjustment after replacement
14. AT head position adjustment
(Refer to Section 5-8).
To Next Page