1-1. DSR-2000
Chapter 3 Recording and Playback
56
Chapter 3 Recording and Playback
Storing a varying playback speed in memory
To store the playback speed for DMC playback, use the following
procedure.
1
Press the DMC EDIT button, turning it on.
2
Either while playing back the recorded tape, or during recording, press
the ENTRY/SHIFT button and each of the following buttons
simultaneously, to set the start and end points.
• On-air start point: AUDIO IN button
• Speed variation start point: IN button
• Speed variation end point: OUT button
• On-air end point: AUDIO OUT button
Each press turns the corresponding button on.
3
Press the SEARCH button or search dial so that the SHUTTLE
indicator in the display section is lit.
4
If you want to use the variable mode to set the varying playback speed,
press the VARIABLE button, turning it on.
5
Holding down the DMC EDIT button, turn the search dial, to set the
initial speed at the speed variation start point.
The speed you set appears in the display section. During this period the
tape does not move.
6
Press the PREVIEW button.
The tape is prerolled and played back at normal speed from the on-air
start point to the speed variation start point. On passing the speed
variation start point, the MEMORY indicator begins to flash, and
playback begins at the speed set in step 5.
MEMORY indicator
Chapter 3 Recording and Playback
Chapter 3 Recording and Playback
57
7
Turn the search dial to vary the playback speed.
While the MEMORY indicator is flashing, the speed variations are
stored in memory. On passing the speed variation end point, the
MEMORY indicator changes from flashing to continuously lit, and the
variable speed storing ends.
8
Press the STOP button to stop the tape.
If the MEMORY indicator lights continuously before the speed
variation end point
This indicates that the memory became full at that point. It is therefore not
possible to record more speed variation. The maximum capacity is a
duration of 120 seconds.
To amend the stored speed variation
Press the PREVIEW button.
The interval between the speed variation start and end points is
automatically played back at the stored speed. Operate the search dial as
required, to adjust the playback speed.
Setting the initial speed to normal speed
In step 5, press the PLAY button.
Executing DMC Playback
There are two methods of starting DMC playback.
•Starting playback at the on-air cue from the on-air start point
•Starting playback immediately after preroll
Notes
•To avoid operating mistakes we recommend that you use the VCR in
standalone mode when carrying out DMC playback.
•When using two VCRs connected for editing, you can only use the
recorder VCR for DMC playback, and only when both the RECORDER
and PLAYER buttons are off.
To Next Page
