9-16
HDS-7150/7100
F1 F2 F3 F4 F5 F6 F7
F8
F9 F10
BUS
SELECT
OUTPUT
THROUGH
BUTTON
No.
INPUT
THROUGH
OFF
9-3-10. Setting about the Change of Synchronization Signal Assignment
n
This setting is valid only when the frequency mode is set to 59.94 or 60.00.
(1) In the set-up menu screen, press the keys on the display panel in the following sequence.
[2] (INPUT/OUTPUT), [F5] (THRU MODE)
The function key indications change as follows.
(2) While pressing the [F3] (BUTTON No.) key, press the desired crosspoint button on the AUX bus
block.
Or, while pressing the [F3] (BUTTON No.) key press the [(] or [)] key.
The crosspoint button to be set is selected.
(3) Press the [F5] (INPUT THROUGH) key.
Every time the key is pressed, the through mode of the input is selected to ON/OFF.
(4) Repeat the steps (2) and (3) to select all input signals.
(5) Press the [F7] (BUS SELECT), [(], or [)] key to move the cursor key to the desired output bus.
(6) Press the [F8] (OUTPUT THROUGH) key.
Every time the key is pressed, the through mode of the output is selected to ON/OFF.
(7) Repeat the steps (5) and (6) to set all output buses.
n
Only when the both through modes of the input and output are selected to ON, the synchronization signal
is used without changing. The synchronization signal generated in the switcher is added to the signal such
as COLOR BKGD and BLACK generated in the switcher regardless of the setting.
HDS-7150
9-3. Set-up
To Next Page
Loading...
