Sony HDS-7150 - Installation of BKDS-7001

7-10
HDS-7150/7100
CN12
CPU-246 board
CN13
IF-523 board
PSW3 x 8
PSW3 x 8
Support
7-2-2. Installation of BKDS-7001
Contents of BKDS-7001
IF-523 board : 1 pc
Screw (PSW3 x 8) : 2 pcs
(1) Open the panel. (Refer to Section 4-6.)
(2) Turn off the power switches in the control panel. (Refer to “7-2-1. Turning On/Off the power”.)
(3) Connect the CN1 (IF-523 board) to the CN12 (CPU-246 board). Connect the CN2 (IF-523 board) to
the CN13 (CPU-246 board).
(4) Secure the IF-523 board to the supports on the CPU-246 board by the two screws (PSW3 x 8)
supplied with the BKDS-7001.
(5) Turn on the power switches in the control panel. (If the one power unit is installed, turn on the power
switch of the side that the power unit is installed in.)
(6) Close the panel.
7-2. Installation of Options for BKDS-7071