4-11
HDS-7150/7100
4-8. Adjustment of Fader Lever
Without removing the fader from the panel, the operating force of the fader lever can be adjusted.
(1) Open the panel. (Refer to Section 4-6.)
(2) When adjusting the fader lever (BKDS-7030) installed to the adaptor box (BKDS-7075), remove the
two screws and then remove the AD panel.
(Refer to step (1) in “7-2-4. Installation of BKDS-7030/7031/7033”.)
(3) Turn the screw by an L shaped hex. wrench (across 4.0 mm) and adjust the operating force.
2 : If turning the screw clockwise, the operating force of the fader lever becomes heavier.
3 : If turning the screw counterclockwise, the operating force of the fader lever becomes lighter.
BKDS-7017
4-8. Adjustment of Fader Lever
* This is the illustration of the BKDS-7017.
Fader assembly
L shaped hex. wrench
(4.0 mm)
Screw
To Next Page
Loading...
