10-16
HDS-7150/7100
10-3-9. Setting about the Change of Synchronization Signal Assignment
n
This setting is valid only when the frequency mode is set to 59.94 or 60.
(1) On the set-up menu screen, press the function keys in the following sequence.
[F4] (OUTPUT) → [F6] (THRU)
The OUTPUT THROUGH MODE menu is displayed.
(2) While pressing [F2] (XPT), press an AUX button to select the desired crosspoint button.
The number of the selected crosspoint button appears on the [F2] screen. The setting of the selected
crosspoint button appears on the [F3] screen.
(3) Press [F3] (THRU) to select the synchronization signal.
ON and OFF is switched by pressing [F3].
ON : The synchronization signal that is originally assigned, is used as it is (THRU).
OFF : The original synchronization signal is not used but synchronization signal from other source is
used instead.
(4) Press [F4] (OUTPUT) to select the desired output signal.
The output setting appears on the [F5] screen. EDPVW and AUX1 is switched by pressing [F4].
(5) Press [F5] (THRU) to select the synchronization signal.
ON and OFF is switched by pressing [F5].
ON : The synchronization signal that is originally assigned, is used as it is (THRU).
OFF : The original synchronization signal is not used but synchronization signal from other source is
used instead.
n
If both input ([F3]) and output ([F5]) are set to ON, the synchronization signal that is originally as-
signed, is used as it is (THRU).
F1 F2 F3 F4 F5 F6
OUT
THRU
XPT
10
– – –THRU
OFF OFF
OUTPUT – – THRU
EDPVW
HDS-7100
10-3. Set-up
To Next Page
Loading...
