10-15
HDS-7150/7100
F1 F2 F3 F4 F5 F6
SETUP
OUT
REFPH
0
ADJUST THRU
F1 F2 F3 F4 F5 F6
OUT
ADJ
OUTPUT
PGM
White
0.0
Dark
0.0
10-3-7. Adjusting the Outputs of the Entire System
(1) On the set-up menu screen, press [F4] (OUTPUT).
The OUTPUT menu is displayed.
(2) Rotate knob 2 to adjust the reference output (REF OUT) phase (normally set to 0).
10-3-8. Adjusting the Output Signal
(1) On the set-up menu screen, press the function keys in the following sequence.
[F4] (OUTPUT) → [F3] (ADJUST)
The OUTPUT ADJUST menu is displayed.
(2) Press [F2] (OUTPUT) to select the desired output signal.
The selected output signal appears on the [F2] screen.
The output is changed by pressing [F2] in the following sequence.
(3) Press [F3] (White).
Rotate knob 3 to adjust the white clip value of the luminance signal.
(4) Press [F4] (Dark).
Rotate knob 4 to adjust the dark clip value of the luminance signal.
PGM PVW CLEAN AUX1 EDPVW
HDS-7100
10-3. Set-up
To Next Page
Loading...
