Sony HDS-7150 - Removal of Parts on the Front Side

2-15
HDS-7150/7100
2-6. Removal of Parts on the Front Side
(1) Remove the front panel. (Refer to Section 2-5.)
(2) Remove the ten screws on the two board retainers and the one board holder.
(3) Disconnect the two connectors (CN2) from the CN-1700 boards.
(4) Remove the eight screws on the two fan assemblies.
To install the parts on the front side, carry out in the reverse order of the steps (1) through (4).
HDS-7150/7100
2-6. Removal of Parts on the Front Side
Board holder
PWH4 x 8
PWH4 x 8
PWH4 x 8
PWH4 x 8
PWH4 x 8
Fan assembly
Fan assembly
CN-1700 board
CN-1700 board
CN2
CN2
Board retainer
PWH4 x 8
Board retainer
PWH4 x 8