2-4
HDS-7150/7100
(4) Temporarily secure the bracket and the plate nut (long) to the outer member 1 by the preparated
screws (B4 x 8) for fixing the plate nut (long). While sliding the outer member 2 back-and-forth, to
see the screw hole of the outer member 1, attach the bracket and the plate nut (long).
(5) Temporarily secure the each outer member assembly (bracket) to both sides of the rack by the two
screws (C4 x 12), the two washers (W4), and the plate nut (short) supplied with the RMM-18DV.
Adjust the installation position of the outer member assembly to meet the specification shown in the
figure.
After the adjustment, tighten the screws (B4 x 8) temporarily secured in the step (4).
HDS-7150/7100
2-2. Rack Mounting
C4 x 12
W4
Outer member 1
Bracket
Rack
TOP VIEW
Spec
50
_
0
Plate nut (short)
+
5
Brackets
Plate nut (long)
Outer member 1
B4 x 8
B4 x 8
B4 x 8
B4 x 8
Outer member stopper
(Used for fixing the outer member 2.)
Plate nut (long)
Outer member 2
Bracket
Rack
Outer member
assembly
C4 x 12
W4
44.45
12.7
Plate nut (short)
Unit : mm
To Next Page
Loading...
