MAP-S1
37
2-5. Auto Standby Test
It can confi rm the auto standby function operates normally.
The auto standby function operates in 60 seconds in this mode.
(Usually, it takes 15 minutes)
Procedure:
1. Press the [
?
/
1
] button to turn the power on.
2. Press the [FUNCTION] button on the remote commander to
select the except FM, AM and DAB tuner function.
3. Press the buttons on the remote commander in order of the
[ALPHABET SEARCH] → [9] → [9] → [ENTER].
(Press the next button within three seconds)
4. It enters the auto standby test mode, and the following screen
is displayed on the fl uorescent indicator tube.
(In this mode, “ ”continues lighting up and “STEREO” con-
tinues blinking on the fl uorescent indicator tube)
Screen display of “CD”, “USB FRONT”, “USB REAR”,
“BLUETOOTH”, “LINE IN” function
Sig X XX
STEREO
Blinking
Screen display of “NETWORK” function
Status XX
STEREO
Blinking
Countdown
timer
(60 to 0)
Countdown
timer
(60 to 0)
Signal level
(0 or 1)
5. In the case of the following states, the countdown timer de-
creases. This unit will become standby states if the countdown
timer decreases to “0”.
• Operation is not performed.
• The signal level is lower than threshold.
(“CD”, “USB FRONT”, “USB REAR”, “BLUETOOTH”,
“LINE IN” function only)
• NETWORK audio is stop status.
(“NETWORK” function only)
Releasing method:
Press the buttons on the remote commander in order of the [AL-
PHABET SEARCH] → [9] → [9] → [ENTER].
(Press the next button within three seconds)
To Next Page
Loading...
Need help?
General
