Sony STR-DA2800ES - D-VIDEO Board Block-1

STR-DA2800ES
21
2-13. D-VIDEO BOARD BLOCK-1
Note 1:
In reassembling, use new cable tie
to fasten the clamp same as before.
1 Cut two cable ties.
(See Fig. H)
3 connector
(CN3523)
4 connector
(CN3607)
5 connector
(CN3509)
< Fig. I >
 Wire setting
Note 3:
The wire must not touch heat sink.
D-VIDEO board
2 Remove wire from wiring stopper.
(See Fig. H)
wiring stopper
2 Remove wire from wiring stopper.
(See Fig. I)
6 wire (flat type) (13 core)
(CN3510)
colored line
colored line
Insert is straight to the interior. Insert is incline
wire (flat type)
wire (flat type)
connectorconnector
OK
NG
Note 2:
When installing the wire (flat type),
ensure the colored line.
No slanting after insertion.
cable tiecable tie
cable tie
< Fig. H >
D-VIDEO board
wiring stopper