3-27 (E)
UP-D898MD/X898MD
Installation
10. Attach the stepping motor with the two screws (PS3 x 6).
11. Connect the harness to the connector (CN001) on the SU-167 board.
12. Attach the DC motor assembly with the two screws (PS3 x 4).
n
When replacing the DC motor assembly, apply grease.
. Grease: 7-640-005-36 (SANKOL FG87HSR)
. Grease applying portion: Worm gear of DC motor subassembly
13. Hook the timing belt on the pulley of the stepping motor. Then, insert the idler pulley shaft into the
hole [A] and insert the worm wheel shaft into the hole [B].
14. Attach the motor block assembly with the four screws (BVTT2.6 x 5).
15. Attach the helical extension spring of the tension arm assembly.
To Next Page
Loading...
