Version 5.2 Sourcefire 3D System Installation Guide 115
Using the LCD Panel on a Series 3 Device
Network Configuration Mode
Chapter 5
In Idle Display mode, press any multi-function key to enter the main menu; see
Understanding LCD Panel Components on page 112 .
IMPORTANT! Pressing a multi-function key as the LCD panel enters Idle Display
mode can cause the panel to display an unexpected menu.
Network Configuration Mode
The Sourcefire 3D System provides a dual stack implementation for both IPv4 and
IPv6 management environments. In Network Configuration mode, you can use
the LCD panel to configure the s for a Series
3 device’s management interface:
the IP address, subnet mask or prefix, and default gateway.
By default, the ability to change s using the LCD panel is disabled. You can enable
it during the initial setup process, or using the device’s web interface. For more
information, see
Allowing Network Reconfiguration Using the LCD Panel on
page 117 .
WARNING! Enabling this option can present a security risk. You need only
physical access, not authentication, to configure s using the LCD panel.
To configure s using Network Configuration mode:
1. In Idle Display mode, press any multi-function key to enter the main menu.
The main menu appears:
Network Config
System Status
2. Press the right arrow (à) key on the top row to access Network Configuration
mode.
The LCD panel displays the following:
IPv4
IPv6
3. Press the right arrow key to select the IP address you want to configure.
• For IPv4, the LCD panel might display the following:
IPv4 set to DHCP.
Enable Manual?
• For IPv6, the LCD panel might display the following:
IPv6 Disabled.
Enable Manual?
To Next Page
Loading...