Version 5.2 Sourcefire 3D System Installation Guide 162
Hardware Specifications
Sourcefire 7000 Series Devices
Chapter 6
Sourcefire 3D7115 and 3D7125
The 3D7115 and 3D7125 devices, part of the 71xx Family, are delivered with
four-port copper interfaces with configurable bypass capability, and eight
hot-swappable small form-factor pluggable (SFP) ports without bypass capability.
To ensure compatibility, use only Sourcefire SFP transceivers. See
Sourcefire
Series 3 Information on page 232 for safety considerations for 71xx Family
appliances.
See the following sections for more information:
• 3D7115 and 3D7125 Chassis Front View on page 162
• 3D7115 and 3D7125 Chassis Rear View on page 168
• 3D7115 and 3D7125 Physical and Environmental Parameters on page 170
3D7115 and 3D7125 Chassis Front View
The front of the chassis contains the LCD panel, USB port, front panel, copper
sensing interfaces, and SFP sockets.
3D7115 and 3D7125 (Chassis: GERY-1U-8-4C8S-AC) Front View
Cooling
requirements
900 BTU/hour
You must provide sufficient cooling to maintain the appliance within its
required operating temperature range. Failure to do this may cause a
malfunction or damage to the appliance.
Acoustic noise 64 dBA at full processor load, normal fan operation
Meets GR-63-CORE 4.6 Acoustic Noise
Operating shock Complies with Bellecore GR-63-CORE standards
Airflow
140 ft
3
(3.9 m
3
) per minute
Airflow through the appliance enters at the front and exits at the rear with no
side ventilation.
3D7110 and 3D7120 Physical and Environmental Parameters (Continued)
PARAMETER DESCRIPTION
LCD Panel USB 2.0 Port Copper Sensing InterfacesFront Panel
SFP Sockets
To Next Page
Loading...