Source fire Sourcefire 3D System - Page 170

Version 5.2 Sourcefire 3D System Installation Guide 170
Hardware Specifications
Sourcefire 7000 Series Devices
Chapter 6
The power supply modules are located on the rear of the appliance. The following
table describes the LED associated with the power supply.
3D7115 and 3D7125 Physical and Environmental Parameters
The following table describes the physical attributes and the environmental
parameters for the appliance.
3D7115 and 3D7125 Power Supply LED
LED DESCRIPTION
Off The power cord is not plugged in.
Red No power supplied to this module.
OR
A power supply critical event, such as module failure, a
blown fuse, or a fan failure; the power supply shuts down.
Blinking red A power supply warning event, such as high temperature
or a slow fan; the power supply continues to operate.
Blinking green AC input is present; volts on standby, the power supply is
switched off.
Green The power supply is plugged in and on.
3D7115 and 3D7125 Physical and Environmental Parameters
PARAMETER DESCRIPTION
Form factor 1U
Dimensions (D x W x H) 21.6 in. x 19.0 in. x 1.73 in. (54.9 cm x 48.3 cm x 4.4 cm)
Weight
maximum installed
29.0 lbs. (13.2 kg)
Copper 1000BASE-T Gigabit copper ethernet bypass-capable interfaces in a paired
configuration
Cable and distance: Cat5E at 50 m
Copper 1000BASE-T SFP Gigabit copper ethernet non-bypass capable interfaces in a paired
configuration
Cable and distance: Cat5E at 50 m