Version 5.2 Sourcefire 3D System Installation Guide 117
Using the LCD Panel on a Series 3 Device
Network Configuration Mode
Chapter 5
8. Edit the subnet mask or prefix the same way you edited the IP address, and
press the check mark key to accept the changes.
The LCD panel displays the following:
Default Gateway - +
000.000.000.000 X
9. Edit the default gateway the same way you edited the IP address, and press
the check mark key to accept the changes.
The LCD panel displays the following:
Save?
X
10. Press the check mark key to save your changes.
Allowing Network Reconfiguration Using the LCD Panel
Because it presents a security risk, the ability to change s using the LCD panel is
disabled by default. You can enable it during the initial setup process (see
Setting
Up a Series 3 Device on page 89), or using the device’s web interface as
described in the following procedure.
To allow network reconfiguration using a device’s LCD panel:
A
CCESS: Admin
1. After you complete the initial setup of the device, log into the device’s web
interface using an account with Administrator privileges.
2. Select System > Local > Configuration.
The Information page appears.
3. Click Network.
The s page appears.
4. Under LCD Panel, select the Allow reconfiguration of s check box. When the
security warning appears, confirm that you want to enable this option.
TIP! For information on the other options on this page, see the Sourcefire 3D
System User Guide.
5. Click Save.
The s are changed.
To Next Page
Loading...