Source fire Sourcefire 3D System - Identifying the Module Parts

Version 5.2 Sourcefire 3D System User Guide 258
Inserting and Removing 8000 Series Modules
Identifying the Module Parts
Appendix C
• quad-port 1000BASE-SX fiber non-bypass NetMod.quad-port 1000BASE-SX
fiber non-bypass NetMod. For more information, see Quad-Port 1000BASE-
SX Fiber Non-Bypass NetMod on page 194.
• quad-port 10GBASE (MMSR or SMLR) fiber non-bypass NetMod. For more
information, see Quad-Port 10GBASE (MMSR or SMLR) Fiber Non-Bypass
NetMod on page 195.
WARNING! The quad-port 10GBASE fiber non-bypass NetMod contains
non-removable small form factor pluggable (SFP) transceivers. Any attempt
to remove the SFPs can damage the module.
• stacking module. For more information, see Stacking Module on page 197.
If you install a NetMod in an incompatible slot on your appliance or a NetMod is
otherwise incompatible with your system, an error or warning message appears
in the web interface on the managing Defense Center when you attempt to
configure the NetMod. Contact Sourcefire support for assistance.
IMPORTANT! Replacing a NetMod can alter the configuration of a fully
configured Korean-certified (KCC mark) appliance. For more information, see the
original configuration documentation for your appliance and Chassis and NetMod
Designations on page 235.
Identifying the Module Parts
All modules contain the same parts, regardless of sensing interface, speed, or
size of the module.
Sample Module or Slot Cover (open)
T8 Torx screw hole
Lever
Lever hole
EMI gasket
Latch
Near end of latch
Far end of latch
Module slot