Source fire Sourcefire 3D System - Information Mode

Version 5.2 Sourcefire 3D System Installation Guide 119
Using the LCD Panel on a Series 3 Device
Information Mode
Chapter 5
2. Press the right arrow ( ) key on the bottom row to access System Status
mode.
The LCD panel displays the following:
Resources 
Link State 
3. Scroll through the options by pressing the down arrow () key. Press the
right arrow key in the row next to the status you want to view.
Depending on the option you chose, the LCD panel displays the information
listed in the System Status Mode Options table on page 118. To change the
LCD panel brightness or contrast, see the next procedure.
To adjust the LCD panel brightness or contrast:
1. In System Status mode, scroll through the options by pressing the down
arrow (
) key until the LCD panel displays the LCD Brightness and LCD
Contrast options:
LCD Brightness 
LCD Contrast 
2. Press the right arrow key in the row next to the LCD display feature
(brightness or contrast) you want to adjust.
The LCD panel displays the following:
Increase
Decrease
3. Press the right arrow key to increase or decrease the display feature you have
selected.
The LCD display changes as you press the keys.
4. Press the down arrow to display the Exit option:
Decrease
Exit
5. Press the right arrow key in the Exit row to save the setting and return to the
main menu.
Information Mode
The LCD panel’s Information mode displays identifying system information such
as the device’s chassis serial number, IP address, model, and software and
firmware versions. Sourcefire Support may require this information if you call for
assistance.