Version 5.2 Sourcefire 3D System Installation Guide 120
Using the LCD Panel on a Series 3 Device
Information Mode
Chapter 5
The following table describes the information available in this mode.
To enter Information mode and view identifying system information:
1. In Idle Display mode, press any multi-function key to enter the main menu.
The main menu appears:
Network Config
System Status
2. Scroll through the modes by pressing the down arrow () key until the LCD
panel displays Information mode:
System Status
Information
3. Press the right arrow ( ) key on the bottom row to access Information mode.
4. Scroll through the options by pressing the down arrow (
) key. Press the
right arrow key in the row next to the information you want to view.
Depending on the option you chose, the LCD panel displays the information
listed in the Information Mode Options table on page 120.
Information Mode Options
OPTION DESCRIPTION
IP address Displays the IP address of the device’s management
interface.
Model Displays the device’s model.
Serial number Displays the device’s chassis serial number.
Versions Displays the device’s system software and firmware
versions. Use the multi-function keys to scroll through the
following information:
• Product version
• NFE version
• Micro Engine version
• Flash version
• GerChr version
To Next Page
Loading...