Source fire Sourcefire 3D System - Page 161

Version 5.2 Sourcefire 3D System Installation Guide 161
Hardware Specifications
Sourcefire 7000 Series Devices
Chapter 6
3D7110 and 3D7120 Physical and Environmental Parameters
The following table describes the physical attributes and the environmental
parameters for the appliance.
3D7110 and 3D7120 Physical and Environmental Parameters
PARAMETER DESCRIPTION
Form factor 1U
Dimensions (D x W x
H)
21.6 in. x 19.0 in. x 1.73 in. (54.9 cm x 48.3 cm x 4.4 cm)
Weight
maximum installed
27.5 lbs. (12.5 kg)
Copper 1000BASE-T Gigabit copper Ethernet bypass-capable interfaces in a paired configuration
Cable and distance: Cat5E at 50 m
Fiber 1000BASE-SX Fiber bypass-capable interfaces with LC connectors
Cable and distance: SX is multimode fiber (850 nm) at 550 m (standard)
Power supply 450 W dual redundant (1+1) AC power supplies
Voltage: 100 VAC to 240 VAC nominal (85 VAC to 264 VAC maximum)
Current: 3A maximum for 90 VAC to 132 VAC, per supply
1.5A maximum for 187 VAC to 264 VAC, per supply
Frequency range: 47 Hz to 63 Hz
Operating
temperature
5
o
C to 40
o
C (41
o
F to 104
o
F)
Non-operating
temperature
-20
o
C to 70
o
C (-29
o
F to 158
o
F)
Operating humidity 5% to 85% non-condensing
Non-operating
humidity
5% to 90%, non-condensing with a maximum wet bulb of 28
o
C (82
o
F) at
temperatures from 25
o
C to 35
o
C (77
o
F to 95
o
F)
Store the unit below 95% non-condensing relative humidity. Acclimate below
maximum operating humidity at least 48 hours before placing the unit in
service.
Altitude 0ft (sea level) to 5905 ft (1800 m)