Version 5.2 Sourcefire 3D System Installation Guide 227
Safety and Regulatory Information
Safety Warning Statements
Chapter 8
Statement 2
CAUTION! When replacing the lithium battery, use only an equivalent type battery
recommended by the manufacturer. If your system has a module containing a
lithium battery, replace it only with the same module type made by the same
manufacturer. The battery contains lithium and can explode if not properly used,
handled, or disposed of.
Do not:
• Throw or immerse into water.
• Heat to more than 100° C (212° F).
• Repair or disassemble.
Dispose of the battery as required by local ordinances or regulations.
Statement 3
CAUTION! When laser products (such as CD-ROMs, DVD drives, fiber optic
devices, or transmitters) are installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
• Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER! Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following. Laser radiation when open. Do not stare into the beam,
do not view directly with optical instruments, and avoid direct exposure to the
beam.
Statement 4
CAUTION! Use safe practices when lifting.
Statement 5
CAUTION! The power-control button on the device and the power switch on the
power supply do not turn off the electrical current supplied to the device. The
device also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
Statement 6
CAUTION! Never remove the cover on a power supply or any part that has the
following label attached.
To Next Page
Loading...