P340 flexiprobe Operation Manual 32
How to update your controller software
Pearpoint may issue P340 system software updates to enhance system performance. To find out if
Pearpoint has released a new software update, please visit www.radiodetection.com or contact your local
Pearpoint representative. It is highly recommended that you periodically check for new software releases
and update your controller when software is made available.
These Controller Software Updates are free of charge.
NOTE: Your system may already have the latest software installed. Check the software version of the file
you are about to use or download against your controller’s software version which you can access by
pressing Fn + F4.
Updating the software is straightforward. To update your software, please observe the following
warnings and procedure:
If using a memory storage device that contains survey files, or other valuable files, be sure to back up the
data on to your computer before continuing this procedure.
CAUTION: Do not switch off the controller or remove the memory storage device while the upgrade is
in progress. Failure to comply may render the controller inoperable.
Radiodetection recommends using the mains adaptor for software upgrades. This is to ensure a
reliable power source.
1. Check for new updates at www.radiodetection.com, by selecting Downloads, Inspection, and
Software Downloads. P340 users should select ‘Pearpoint P340 USB and Radiodetection
GatorCam4USB software updates’.
2. Download the new software to your computer.
3. Double-click on the file downloaded to extract the update binary file.
4. Save the P340_GC4.bin file to the root of the removable memory storage device you are
using.
5. Insert your removable memory device into your controller and turn it on.
6. Navigate to the “Upload Controller Software” Menu (select: Menu->Setup -> Maintenance) and
follow the on-screen instructions to complete the upgrade.
7. The controller will now update the software and then prompt you to restart the module by pressing
OK.
8. The update process may take several minutes. Do not remove the memory device or switch off the
system until the update is complete.
9. The controller has now been updated.
To Next Page
Loading...