P340 flexiprobe Operation Manual 59
5. Cont. Defect: Identify a defect which extends or repeats beyond the first meter from the camera
position.
6. Code: Defect Code.
7. Joint: Identify if the observation relates to a pipe joint.
8. Material: Pipe’s material; by default you can choose between WRCs MSSC 3 pipe materials
identification.
9. Band: Medium or large. This is associated to specific codes.
10. Dimension 1: Pipe dimension 1 associated to the defect code entered (10 characters maximum).
11. Dimension 2: Pipe dimension 2 associated to the defect code entered (10 characters maximum).
12. %: Percentage value associated to the defect code entered.
13. Clock at/from: Defect position as requested by the defect code entered.
14. Clock to: Defect position as requested by the defect code entered.
15. Remarks: Remarks (30 characters maximum).
16. Grade: Grade associated with the defect code entered.
Adding a photo to an observation.
1. Go to the Photo field and press OK.
2. Select a photo in the photo browser screen showing all the photos present in the survey’s folder.
3. Press USE to add the selected photo to the observation.
4. Press SHOW to review the highlighted picture. When reviewing a picture you can also:
Use the ▲ and ▼ keys to show the other folder’s photo.
Press USE to add the selected photo to the observation.
Press BROWS to return to the previous screen.
5. Press CANCL to exit.
NOTE: An error message will appear if the picture is not suitable. This may happen if you are trying to use
an incompatible photo not generated by the P340 controller.
To Next Page
Loading...