Stober SC6 Series - Page 136

12 | Diagnostics STOBER
136
05/2019 | ID 442790.01
Event
Event 60: Application event 0 – Event 67:
Application event 7 [}160]
Event 68: External fault 2 [}161]
Event 69: Motor connection [}162]
Event 70: Parameter consistency [}163]
Event 71: Firmware [}164]
Event 72: Brake test timeout [}165]
Event 76: Position encoder [}166]
Event 77: Master encoder [}169]
Event 78: Position limit cyclic [}171]
Event 79: Motor / position monitor [}172]
Event 80: Illegal action [}173]
Event 81: Motor allocation [}173]
Event 83: Failure of one/ all phases (mains) [}174]
Event 84: Drop in network voltage when power section active [}175]
Event 85: Excessive jump in reference value [}176]
Event 86: Unknown LeanMotor record [}177]
Event 87: Reference lostReference loss [}178]
Event 88: Control panel [}179]
Event 89: Maximum current Lm [}180]
Tab. 147: Events