VENT VALVE
EMISSION CONTROL
(AUX.
EMISSION CONTROL DEVICES)
13.Vent
Valve
A:
REMOVAL
1)
Remove the fuel tank. <Ref. to FU(D0HC
TUR-
BO)-52,
REMOVAL,
Fuel Tank.>
2)
Remove the protector cover.
I
EN1
050
I
3)
Remove the clips, and disconnect the hoses
from vent valve.
4)
Remove the nuts which install the vent on fuel
tank.
I-
B:
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Replace the rubber seat with
a
new one.
Tightening
torque:
T: 4.4 N.m
(0.45
kgf-m,
3.3
ft-lb)
C: INSPECTION
Make sure the hoses are not cracked or loose.
EC(D0HC TURBO)-15
To Next Page
Loading...
