Appendix F Serial Attached SCSI BIOS Configuration Utility F-5
Use the arrow keys to select an adapter, then press Enter to view and modify the
selected adapter’s properties (and to access the other screens). After you select an
adapter and press Enter, the adapter’s devices are scanned and the “Adapter
Properties Screen” on page 7 appears.
To change the Adapter boot order, use the -, +, Insert, and Delete keys while on the
Boot Order field. Press Insert or Delete to add or remove an adapter to or from the
boot order. Press the - and + keys to modify an adapter’s position in the boot order.
If you make changes to the boot order, the Configuration Utility prompts you to save
the changes before you exit the screen.
From the Adapter List screen (shown below), you can also press Alt+N to access the
Global Properties screen. On this screen you can change global scope settings.
*******************************************************************************
* LSI Logic MPT Setup Utility v6.02.00.00 (2005.07.08) *
* Adapter List Global Properties *
* Adapter PCI PCI PCI PCI FW Revision Status Boot *
* Bus Dev Fnc Slot Order *
* SAS1064 02 03 00 00 1.04.00.00-IR Enabled 0 *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* Esc = Exit Menu F1/Shift+1 = Help *
* Alt+N = Global Properties -/+ = Alter Boot Order Ins/Del = Alter Boot List *
*******************************************************************************
To Next Page
Loading...
