Appendix F Serial Attached SCSI BIOS Configuration Utility F-17
■ All: Reassign the current block, and automatically reassign other blocks that need
it, without displaying the prompt again.
■ nonE: Do not reassign the current block, and do not automatically reassign any
other blocks that need it. Do not display the prompt again.
■ Cancel: Do not reassign anything, and stop the verification process.
F.3.8 Advanced Adapter Properties Screen
The Advanced Adapter Properties screen (shown below) allows you to view and
modify infrequently accessed adapter settings.
TABLE F-8 describes the fields of the
screen.
The Advanced Adapter Properties screen provides access to advanced Device
Properties and PHY Properties. To modify the Link Error Settings Threshold Count
and Threshold Time, press Enter while the cursor is on the desired field and type the
new value.
********************************************************************************
* LSI Logic MPT Setup Utility v6.02.00.00 (2005.07.08) *
* Advanced Adapter Properties -- SAS1064 *
* *
* IRQ 0B *
* NVM Yes *
* IO Port Address A800 *
* Chip Revision ID 02 *
* *
* Spinup Delay (Secs) [ 2] *
* CHS Mapping [SCSI Plug and Play Mapping] *
* *
* Link Error Threshold Threshold *
* Settings Count Time(Secs) *
* Invalid DWORDs 0 0 *
* Loss of DWORD Sync 0 0 *
* Running Disparity Errors 0 0 *
* PHY Reset Errors 0 0 *
* *
* Advanced Device Properties *
* PHY Properties *
* Restore Defaults *
* Esc = Exit Menu F1/Shift+1 = Help *
* Enter = Select Item -/+ = Change Item *
********************************************************************************
To Next Page
Loading...
