F-24 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
After the volume is configured, press C to create the array. You are asked to save
changes, which will create the array. After the array is created, the utility returns you
to the Adapter Properties screen.
********************************************************************************
* LSI Logic MPT Setup Utility v6.02.00.00 (2005.07.08) *
* Create New Array -- SAS1064 *
* Array Type: IM *
* Array Size(MB): 69618 *
* *
* Scan Device Identifier RAID Hot Drive Pred Size *
* ID Disk Spr Status Fail (MB) *
* 2 FUJITSU MAV2073RCSUN72G 0301 [Yes] [No] Primary --- 70007 *
* 3 FUJITSU MAV2073RCSUN72G 0301 [Yes] [No] Secondary --- 70007 *
* *
* *
* *
* *
* *
* *
* *
* Esc = Exit Menu F1/Shift+1 = Help *
* Space/+/- = Select disk for array or hotspare C = Create array *
********************************************************************************
TABLE F-10 Create New Array Screen Field Descriptions
Field Description
Array Type The type of array being created: IM or IS.
Array Size The size of the array, in Mbytes.
Scan ID The order in which devices are scanned.
Device Identifier The ASCII device identifier string extracted from the device’s inquiry
data.
RAID Disk Specifies whether the disk is part of a RAID array (Yes or No). This
field is grayed out under the following conditions:
• The disk does not meet the minimum requirements for use in a
RAID array.
• The disk is not large enough to mirror existing data on the primary
drive.
• This disk has been selected as the hotspare for the RAID array.
To Next Page
Loading...
