Sun Microsystems Sun Fire X4100 - Page 262

F-32 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
********************************************************************************
* LSI Logic MPT Setup Utility v6.02.00.00 (2005.07.08) *
* *
* *
* *
* *
* *
* *
* *
* *
* Adapter and/or device property changes have been made. *
* Cancel Exit *
* Save changes then exit this menu *
* Discard changes then exit this menu *
* Exit the Configuration Utility and Reboot *
* *
* *
* *
* *
* *
* *
* *
* Esc = Exit Menu F1/Shift+1 = Help *
* *
********************************************************************************
F.4 Performing RAID Configuration Tasks
This section contains the following information and instructions for using the
Configuration Utility to set up RAID:
■ Section F.4.1, “RAID Implementation and Support” on page F-33
■ Section F.4.2, “Creating a RAID 0 Volume” on page F-35
■ Section F.4.3, “Creating a RAID 1 Volume” on page F-36
■ Section F.4.5, “Creating a Second RAID Volume” on page F-38
■ Section F.4.6, “Viewing RAID Volume Properties” on page F-38
■ Section F.4.4, “Managing Hot Spares” on page F-37
■ Section F.4.7, “Synchronizing an Array” on page F-38
■ Section F.4.8, “Activating an Array” on page F-39
■ Section F.4.9, “Deleting an Array” on page F-39
■ Section F.4.10, “Locating a Disk Drive” on page F-40