Appendix F Serial Attached SCSI BIOS Configuration Utility F-31
F.3.11.5 Exit Screen
It is important to exit the SAS BIOS Configuration Utility correctly, because some
changes take effect only when you exit.
From the Adapter List, press the Esc key to exit.
In addition, a similar Exit screen appears when you exit most other screens, and it
can be used to save settings. The Exit screen is shown below. Some options on the
Exit screen might be grayed out, indicating that they are not available at this time.
Synchronize Array Press Enter to synchronize the RAID array. This field is grayed out
under the following conditions:
• The array is inactive.
• The array does not need to be resynchronized.
• The adapter’s MPT FW does not support the feature.
• Integrated Striping firmware is used.
Activate Array This field is used to activate a RAID array.
Delete Array This field is used to delete the currently displayed RAID array.
TABLE F-12 Manage Array Screen Field Descriptions (Continued)
Field Description
To Next Page
Loading...
