A.5 Interpreting the LEDs
A.5.1
The "DSL" LED blinks slowly
1. Check the connection of your xDSL filters. Each telephone socket of your installation being used
must be equipped with an xDSL filter.
2.
Check that the RJ11 type line cord delivered with your Sunrise Internet Box is connected to one of
your sockets. It is recommended that no telephone extension be used.
3.
Finally, check with your ISP that the DSL service is available on your telephone line.
A.5.2
"Wi-Fi" LED off
If this LED is off, this indicates that the WLAN interface of the Sunrise Internet Box is not active.
To activate the wireless network, access the graphical User Interface (http://192.168.1.1) and check the
box "Enable Wireless" in the Wireless menu (see Section 3.7).
A.5.3
All LEDs are off
1. Check that the type of power available in your premises is compatible with the electrical power
supply voltage required for powering your Sunrise Internet Box.
2.
Check that the delivered power supply unit is properly connected at one end to the electrical power
supply network.
3.
Check that the power connector is inserted correctly in the corresponding power connector of the
Sunrise Internet Box.
4.
Simultaneously press the Wi-Fi + DECT buttons and make sure the LED brightness is not disabled
(see Section 3.3.9 - Auto-dimming).
To Next Page
Loading...
