7-42 CHASSIS
DUST SEAL
• Install the new dust seals with the special tool.
$ 09913-70210: Bearing installer set (
1 & 62)
(
2 & 47)
NOTE:
When installing the dust seals, the stamped mark of dust seal
must face the special tool.
• Apply SUZUKI SUPER GREASE to the dust seal lips before
assembling rear wheel.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
BRAKE DISC
Make sure that the brake disc is clean and free of any greasy
matter.
NOTE:
The stamped mark
A
on the brake disc should face to the out-
side.
• Apply THREAD LOCK to the disc bolts and tighten them to
the specified torque.
(99000-32130: THREAD LOCK SUPER “1360”
! Brake disc bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
REAR SPROCKET
• Install the rear sprocket to the rear sprocket mounting drum.
NOTE:
Stamped mark
A
on the sprocket must face outside.
• Apply SUZUKI SUPER GREASE to the rear sprocket mount-
ing retainer.
• Install the rear sprocket mounting drum retainer
1 as shown.
• Apply SUZUKI SUPER GREASE to the contacting surface
between the rear wheel and the sprocket drum.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
PartShark.com
877-999-5686
To Next Page
Loading...
