• Disconnect the throttle cables from their drum.
• Dismount the throttle body assembly.
%
THROTTLE BODY DISASSEMBLY
%
• Remove the vacuum hoses (1, 2).
• Disconnect the fuel feed hose 3.
• Remove the throttle link rod 4 and secondary throttle link rod
5.
NOTE:
The throttle link rod 4 is longer than the secondary throttle link
rod 5.
• Remove the fuel delivery pipe/hose 6.
* Be careful not to damage the throttle cable bracket
and fast idle lever when dismounting or remounting
the throttle body assembly.
* After disconnecting the throttle cables, do not snap
the throttle valve from full open to full close. It may
cause damage to the throttle valve and throttle body.
* Be careful not to damage the throttle lever when dis-
assembling the throttle body.
* The throttle body is assembled precisely in factory.
Do not disassemble it other than shown in this man-
ual.
DL650K7/AK7 (’07-MODEL) 13-53
PartShark.com
877-999-5686
To Next Page
Loading...
