ABS INDICATOR LIGHT INSPECTION
Step 1
1) Check if the ABS indicator light lights up when turning the
ignition switch to ON.
NOTE:
If the ABS indicator light flashes, there may be a short-circuit
existing in the mode select switch wire.
Does the ABS indicator light up?
The ABS indicator light lights up
Step 2
1) Ride the motorcycle at more than 5 km/h (3.1 mile/h).
Does the ABS indicator light go off?
The ABS indicator light does not light up
Step 3
1) Remove the seat. (!DL650K4 7-4)
2) Open the fuse box and inspect the signal fuse 1.
Signal fuse: 15 A
Is the signal fuse OK?
%
YES Go to step 2.
NO Go to step 3.
YES Normal (No DTC exists)
NO
DTC OUTPUT (!Page 89)
If DTC can not be output (the ABS indicator light
does not flash), go to step 6.
YES Go to step 4.
NO Replace the signal fuse.
If a fuse is blown, find the cause of the problem and
correct it before replacing the fuse.
13-86 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686