Step 4
1) Turn the ignition switch to OFF.
2) Disconnect the ABS control unit coupler. (!Page 84)
3) Turn the ignition switch to ON with the ABS control unit cou-
pler disconnected, measure the voltage between B terminal
and 4 terminal at the coupler.
$ Normal value: 7.5 – 9.5 V and more
# 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
' Tester knob indication: Voltage (()
Is the voltage between B and 4 normal?
Step 5
1) Turn the ignition switch to OFF.
2) Check for continuity between 4 terminal of coupler and body
ground.
+ Tester knob indication: Continuity (*)
Are there continuity between 4 and body ground?
Step 6
The ABS indicator light does not go off
1) Turn the ignition switch to OFF.
2) Remove the seat. (!DL650K 7-4)
3) Open the fuse box and inspect the ignition fuse 1.
Ignition fuse: 10 A
Is the ignition fuse OK?
%
YES Go to step 5.
NO
Inspect the wire harness. (Faulty indicator light
wire or ground wire)
Faulty ABS indicator light.
ABS control unit coupler (Harness end)
YES Replace the ABS control unit/HU.
NO Inspect the wire harness. (Faulty ground wire)
YES Go to step 7.
NO Replace the ignition fuse.
If a fuse is blown, find the cause of the problem and
correct it before replacing the fuse.
ABS control unit coupler
(Harness end)
DL650K7/AK7 (’07-MODEL) 13-87
PartShark.com
877-999-5686
To Next Page
Loading...
