ABS CONTROL UNIT/HU
REMOVAL
"
%
• Remove the seat. (!DL650K4 7-4)
• Remove the battery.
• Drain the brake fluid. (!DL650K4 7-71)
• Disconnect the following parts from the battery case 1.
2 Fuse box and turn signal/side-stand relay
3 Starter relay
4 Fuel pump relay
5 ABS valve relay fuse
6 ABS motor relay fuse
7 TO sensor
• Remove the ABS control unit/HU cover 8.
• Remove the battery case 1.
When storing the brake fluid, seal the container completely and keep away from children.
* This brake system is filled with an ethylene glycol-based DOT 4 brake fluid. Do not mix differ-
ent types of fluid such as silicone-based or petroleum-based.
* Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake
fluid left over from the last servicing or stored for long periods.
* Handle brake fluid with care: the fluid reacts chemically with paint, plastics, rubber materials
etc. and will damage then severely.
* The ABS is made up of many precision parts; never subject it to strong impacts or allow it to
become dirty or dusty.
* The ABS control unit/HU cannot be disassembled.
13-126 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686
To Next Page
Loading...
