3-16 ENGINE
• Adjust the gearshift lever as shown.
& Gearshift lever height
A
Standard: 20 – 30 mm (0.79 – 1.18 in)
• Install the engine sprocket.
• Install the engine sprocket and the washer.
• Apply a small quantity of THREAD LOCK to the drive shaft
thread portion.
%99000-32050: THREAD LOCK “1342”
• Tighten the engine sprocket nut
1 to the specified torque.
$ Engine sprocket nut: 145 N·m (14.5 kgf-m, 105 lb-ft)
• Bend the lock washer.
• Adjust the drive chain slack. (!2-21)
• Tighten the rear axle nut
2 to the specified torque.
$ Rear axle nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Install the cotter pin. (For E-03, 28, 33)
• Apply SUZUKI SUPER GREASE to the clutch push rod and
install it.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
PartShark.com
877-999-5686
To Next Page
Loading...
