ENGINE 3-23
• Remove the cylinder head gasket
5, dowel pins
6 and cam
chain guide
7.
FRONT CYLINDER
• Remove the cylinder nuts
1.
• Remove the cylinder
2.
• Remove the cylinder base gasket
3 and dowel pins
4.
NOTE:
Make sure that the oil jet is inserted in the crankcase.
FRONT PISTON
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlip into the crankcase.
• Remove the piston pin circlip
1.
• Remove the piston
2 by driving out the piston pin.
NOTE:
Scribe the cylinder number on the head of the piston.
REAR CAMSHAFTS
• Rotate the generator 360 degrees (1 turn) counterclockwise
and align the “F” line
A on the generator rotor with the index
mark
B of the valve timing inspection hole.
PartShark.com
877-999-5686
To Next Page
Loading...
