115
16 Vehicle Speed Sensor – No signal for a length of time at pin 16 (orange wire) of the 26 pin ECU connector.
19 Water Temperature Sensor – Voltage at pin 32 (green/white wire) of the 34 pin ECU connector is either higher
than 4.85V or lower than 0.15V. Failsafe Mode: Control system sot that cooling termperature is 83°C (continous
running of radiator fan).
41 Shift Solenoid No. 1 – Open or short circuit at pin 27 (blue/black wire) of the 34 pin ECU connector, should be
“on” if gear selector is in “L” (“on” meaning there should be 12 volts going through this wire).
42 Shift Solenoid No. 2 – Open or short circuit at pin 28 (blue/white wire) of the 34 pin ECU connector, should be
on if gear selector is in “L” or “2” (“on” meaning there should be 12 volts going through this wire).
43 Shift Solenoid No. 3 – Open or short circuit at pin 29 (blue/red wire) of the 34 pin ECU connector.
46 Shift Switch – No signal at pin 18 (green/pink wire) of the 26 pin ECU connector, and no signal at pin 19
(orange/blue wire) of the 26 pin ECU connector, and no signal at pin 20 (orange/green wire) of the 26 pin ECU
connector, and no signal at pin 24 (green/blue wire) of the 26 pin ECU connector, and no signal at pin 25 (green wire)
of the 26 pin ECU connector, and no signal at pin 26 (red wire) of the 26 pin ECU connector.
or
signal present at more than one of pins 18, 19, 20, 24, 25 and 26 of the 26 pin ECU connector.
To Next Page
Loading...
