Suzuki F6A - SECTION 13: SPEED LIMITER

159
Belt tension spec-
ification
11–14 mm (0.43–0.55 in.) as
deflection
NOTE:
When replacing belt with new one, adjust belt ten-
sion to 10–12 mm (0.40–0.47 in.)
3) If the belt is too tight or too loose, adjust it to specifi-
cation by adjusting alternator position.
4) Tighten alternator adjusting bolt and pivot bolt.
5) Connect negative battery lead to battery.
FAULTY INDICATOR LIGHT OPERATION
Symptom Possible Cause Correction
 Fuse blown
Charge light does not light
with ignition ON and engine
 Fuse blown

Light burned out
Check fuse
Re
p
lace light
w
i
t
h
i
gn
i
t
i
on
ON
an
d
eng
i
ne
off
 Light
burned
out
 Wirin
g
connection loose
R
ep
l
ace
li
g
ht
Tighten loose connections
Wiring
connection
loose
 IC regulator faulty
Tighten
loose
connections
Replace IC regulator
 Drive belt loose or worn
Adjust or re
p
lace drive belt
Charge light does not go out
with engine running (battery

D
r
i
ve
b
e
lt
l
oose or worn
 Battery cables loose, corroded
Adj
us
t
or rep
l
ace
d
r
i
ve
b
e
lt
Repair or replace cables
with
engine
running
(battery
requires frequent recharg-
ing)
y,
or worn

IC regulator faulty
Check charging system
 IC
regulator
faulty
 Wiring faulty
Check charging system
Repair wiring