FUEL SYSTEM
AND
THROTTLE
BODY
5-17
Tighten the fuel injector mounting screws to the specified
torque.
rn
Fuel injector mounting screw:
3.5
N.m (0.35 kgf-m, 2.5 lb-ft)
1.
,
I
',,
8,
Tighten the fuel delivery pipe mounting screws to the speci-
fied torque.
Apply thin coat of the engine oil to the O-rings.
Install the fuel delivery pipe
(0
to the injector
(2).
EXIT?
[ZJ
Fuel delivery pipe mounting screw:
3.5
N.m (0.35 kgf-m, 2.5 lb-ft)
r
1,
*The removed O-rings must be replaced with new
ones.
Never turn the fuel delivery pipe while pushing it.
With the throttle valve fully closed, install the
TP
sensor
(3,
.
+
Y-W
and tighten the
TP
sensor mounting screw to the specified
torque.
Y
mEF_1
*
@'~~
The removed O-ring must
be
replaced with a new one.
NOTE:
&\
\
0
Apply thin coat of the engine oil to the O-ring.
/
@
I'
Align the throttle shaft end
60
with the groove
(ij)
of
TP
sensor.
"
Apply grease to the throttle shaft end
Cn!
if
necessary.
1
Ir,.
1
rn
TP
sensor mounting screw:
3.5
N.m (0.35 kgf-m, 2.5 lb-ft)
99000-25010:
SUZUKI SUPER GREASE
"A"
(or
equivalent
grease)
09930-1 1950: Torx wrench
NOTE:
"
Make sure the throttle valve open or close smoothly.
TP
sensor setting procedure.
m4-IS)
To Next Page
Loading...
